Viking Appliance Repair Phoenix, AZ (480) 666-4248
Menu

04 Phoenix · Viking

Viking Dishwasher Repair

Fill, drain, heat and leak diagnosis on Viking panel-front and integrated dishwashers.

Door hinge assembly and its spring laid out on a shop towel with nut drivers, pliers, a wire brush and screws

How people describe it on the phone.

  1. Lights cycle at you and the machine never starts
  2. Cycle runs for hours and never finishes
  3. Dirty water backing up into the tub
  4. Grinding or rattling from under the lower rack

Any one of these is enough to work with. What changed, and when it changed, is worth more than a guess at the part.

What actually gets measured.

Fill and drain
Inlet valve flow, float and pressure switch, then drain pump current and check-valve seating. Dirty water backing up is a drain path, not a pump that has given up.
Heat and cycle
Heater circuit, thermistor reading and the cycle sequence on the board — a wash that runs for hours is usually waiting for a temperature it will never reach.
Door and seals
Latch alignment, hinge tension and gasket condition, which is also where a cabinet leak almost always starts.

03 In their words

Dishwasher Repair calls, told by the people who booked them.

Three Phoenix jobs on this side of the Viking kitchen — the symptom, the fault, the fix.

4.9 / 5904 reviews

  • Dirty water backed up into the tub after our kitchen remodel. The plug in the new disposal inlet had never been knocked out. He found it in minutes and told me plainly what had happened.

    Marisela H.Ahwatukee

  • It would not start at all, just a row of lights cycling at us. The door latch switch had failed, not the control board. Working before he left. Four only because the first slot was a week out.

    Nadira P.Arcadia

  • Awful grinding noise partway through every wash. A chip of glass had worked its way into the pump impeller. He fished it out, checked the seal, and ran a short cycle to prove it.

    Junko R.Ahwatukee

04 What a repair costs

What dishwasher repair costs here.

Every figure below is a range covering parts and labour on Viking equipment. Which end of it you land on depends on the part and how far into the machine it sits — that is a thing to be measured, not guessed at over the phone.

Igniter or burner assembly
$170–$450
Oven thermostat or heating element
$200–$430
Refrigeration fan or defrost system
$280–$680
Dishwasher pump or control likely here
$200–$400
Control board or touch panel likely here
$430–$670
Compressor or sealed-system repair
$1,430–$3,120

Flat $89 service call covering the visit and full diagnosis, credited against the repair once you approve it.

The number is agreed before anything is dismantled. You get the band, then the firm figure once the fault is confirmed on site, and the work starts only after you say yes to it — so the $89 you have already paid comes straight back off the bill.

06 Book the visit

Dishwasher Repair in Phoenix?

Say what it is doing and roughly when it started. Most dishwasher repair faults narrow to two or three candidates before anyone gets in the van.

8:00 am – 8:00 pm, seven days on the road · phone answered 24/7

Appliance kit on a cloth: brush, five nut drivers, pliers, a pulley, a spring and hinge plates with bolts